DIY Concrete Lamp – Led String Light – Life Hacks Tips

DIY Concrete Lamp – Led String Light


I used these lights for an end table. What’s nice about these lights is that all the electronics are hidden. It’s a simple project that requires very little tools and can enhance any space. For more awesome DIY be sure to check out my youtube channel www.youtube.com/c/DIYCreators

Here is a step by step video to make this lamp.

It’s a simple project that requires very little tools and can enhance any space.

I cut the PVC first to create a straight edge. Then I set my stop block to make a 5 inch cut on the miter saw. You can make as many as you’d like, but I made two.

Since the piece of pvc was outside collecting dirt, I gave them a quick wash down so no dirt transfer to the form.

Since the piece of pvc was outside collecting dirt, I gave them a quick wash down so no dirt transfer to the form.

The form needs to be hollow on the inside to hold the LED controller.

You can use what ever you come up with. I used two water bottles as a place holder.

Keep in mind the water needs to me centered in the form. I made the water bottles 1.5 in below the rim of the PVC.

The top of the form need to be small enough at the top for the vase to cover. I used a (1 inch) foam weather strip to prevent the cement from filling this area.

continue reading on next page (>)

source: hometalk.com